Tags

  • Search

  • Sorting

  • Filters

Jon MacGregor

by | 0 Comments

I have a turbo v ion source that shows a glowing blue/purple light at the tip of the Heated Nebulizer corona discharge needle, even when it is not in use and turned out of ion path as it should be when using TIS probe. It only happens in negative mode. It is not arcing to the cutain plate, just a slight noticeable glow at the tip of the corona needle when observed through the front window. My FSE has rebuilt the HN probe and components and also installed a new TIS probe. Still glows when in negative mode. Note also having poor sensitivity in negative mode as well and jagged peak shapes during infusion. Any ideas? Are the symptoms related?

Relative migration time

Standard peaks are noisy

by | , , ,

I am Using Sciex Qtrap 4500 for quantification of nitrosamines (NDMA&NDBA). I am facing issue with higher baseline intensity. When developed the method in APCI the basline was at about 5e4. but now even after cleaning the source (i.e. Changed capillary to new, Curtain plate & Corona needle cleaning, given blank injection overnight ), my base line decreased from 1e6 to 4 e5, but settled at 4 e5 from past 24 hours. can you suggest me how decrease my baseline intensity further to below 1e5. My standard peaks are like noise now.

No Results Found

The page you requested could not be found. Try refining your search, or use the navigation above to locate the post.

No Results Found

The page you requested could not be found. Try refining your search, or use the navigation above to locate the post.

SCIEX Now™ support network
The destination for all your support needs.
Contact support
Wordpress Social Share Plugin powered by Ultimatelysocial